Implementation Engineer DEE-1721 exam is a perfect way of skills authentication and to become prominent in the competitive market as the are authenticated by passing it. Theexams’s DEE-1721 dumps material consist of DEE-1721 practice test software and DEE-1721 pdf files. The DEE-1721 questions of Dell EMC DEE-1721 exam that you learn from the pdf files and practice them on practice test software to strengthen your learning for the best performance in the actual DEE-1721 exam. There are total 62 questions of different types and you are required to complete them in minutes.
|Full Exam Name||SC Series Expert Exam|
|Certification Name||Implementation Engineer|
♥ 2019 Valid DEE-1721 VCE Dumps ♥
DEE-1721 exam questions, DEE-1721 PDF dumps; DEE-1721 exam dumps: DEE-1721 Exam Questions (62 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)
Latest and Most Accurate Dell EMC DEE-1721 VCE Dumps:
Several servers connected to the Storage Center through FC fabrics using WWN zoning. You recently
replaced a server’s FC HBA; however, the server no longer connects to the Storage Center.
What is causing this issue?
A. Storage Cento fault domains must be updated with the new HBA WWN
B. Storage Center fault domains must be converted to Virtual Pat Node
C. Server’s zone must be updated with the new switch port to which the HBA is connected
D. Server’s zone must be updated with the new NBA WWN
A storage administrator has multiple servers connected to the Storage Center through two iSCSI
networks. You use a software iSCSI Initiator on the servers and the Storage Center runs in Virtual Port
Which IP address is required in the iSCSI Initiator for proper connectivity?
A. Primary IP address for each domain
B. Control Port IP address for each domain
C. Reserve IP address for each domain
D. Management IP address of each controller
Which processes should be used when testing controller failover on a newly installed Storage
A. Start server IO to a volume, restart a controller, then rebalance ports and ensure no IO errors.
B. Start server IO to a volume, restart either controller, and ensure no IO errors are reported.
C. Start server IO to volumes owned on each controller, restart the controllers sequentially, and
ensure no IO error.
D. Start server IO to volumes owned on each controller, restart the controllers simutaneously. and
ensure no IO error.
You are troubleshooting disk connectivity issues on an SC9000. The SC9000 has two SC220 enclosures
on one chain and two SC280 enclosures on the other chain. You verify the physical cabling and
discover the array is cabled as shown in the exhibit.
What identities the issue with how the environment is cabled?
A. Chain containing the SC220 storage enclosures is cabled incorrectly
B. Chain containing the SC220 storage enclosures must be divided into two separate chains
C. Chain containing the SC220 storage enclosures is cabled incorrectly
D. Chain containing the SC280 storage enclosures must be divided into two separate chains
After setting up an SC4020 and turning on the system, both controllers initialize to Safe Mode and are
ready for configuration You plug the serial cable into the first controller and type the platform prejoin
show command You then receive the command output shown in the exhibit
If you continued configuring the controller, what are the reasons why the deployment will fair?
A. Serial cable needs to be plugged into the top controller Controller chassis is installed upside down
in the rack
B. Serial cable needs to be plugged into the top controller eth1 IPv4 IP address used at the factory to
load the firmware was not cleared before shipping
C. Serial cable needs to be plugged into the bottom controller eth1 IPv4 IP address used at the
factory to load the firmware was not cleared before shipping
D. Serial cable needs to be plugged into the bottom controller Controller chassis is installed upside
down in the rack
New Updated DEE-1721 Exam Questions DEE-1721 PDF dumps DEE-1721 practice exam dumps: https://www.dumpsschool.com/DEE-1721-exam-dumps.html