Real 300-370 Cisco Exam Question Samples For Free

TestActual is providing 300-370 exam preparation material for Cisco Certified Network Professional Wireless 300-370 exam for last 10 years and has gathered more then 50,000+ satisfied customers around the world. Our success rate for Cisco Certified Network Professional Wireless 300-370 exam is remarkable. You may try the free demo of our Cisco Certified Network Professional Wireless 300-370 exam dumps material, before purchase. We provide you latest 300-370 exam questions. The candidates will also be entitled 90 days free updates.

300-370 exam questions, 300-370 PDF dumps; 300-370 exam dumps:: https://www.dumpsschool.com/300-370-exam-dumps.html (60 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)

Latest and Most Accurate Cisco 300-370 Dumps Exam Questions and Answers:

Version 8.0
Question: 21

A WLAN was installed at a high AP density. DTPC is lowering the transmit power of many APs too low. Which change m the DTPC transmit power threshold must be made to allow APs to globally increase AP transmit power by 3dBm?

A. from 70 dBm to 73 dBm
B. from -70 dBm to -73 dBm
C. from 70 dBm to 67 dBm
D. from -70 dBm to -67 dBm

Answer: D

Question: 22

Which visual cue accurately describes a characteristic of the zone of impact displayed in Cisco Prime Infrastructure?
A. The closer the cirlce is to blue, the more localized the impact is.
B. The smaller the circle, the more localized the impact is.
C. The larger the circle, the more severe the impact is.
D. The more translucent the circle is, the more localized the impact is.

Answer: B

Question: 23

New Updated 300-370 Exam Questions 300-370 PDF dumps 300-370 practice exam dumps: https://www.dumpsschool.com/300-370-exam-dumps.html

An engineer must open a support case with Cisco TAC. Which two commands verify the model and serial number of a controller? (Choose two)

A. show sysinfo
B. show udi
C. show inventory
D. show boot
E. show tech-support

Answer: AB

Question: 24

While reviewing Clean Air data in Cisco Prime Infrastructure, an engineer notices that a wideband jammer is not sending its Interferer Security Trap correctly. The engineer determines that the default seventy level has been changed. Which value does the engineer select to reset the seventy level to its factory setting?

A. informational
B. major
C. minor
D. warning
E. critical

Answer: D

Question: 25

An engineer is using various techniques to discover and isolate rogues on the network. For which technique must the engineer consider legal ramifications?

A. rogue AP containment
B. RF detection
C. switch port tracing
D. wire detection
E. Cisco Prime Infrastructure location services

Answer: A

Question: 26

Which Cisco WLC debug command allows you to determine if the certificate process is failing in the CAPWAP messages?

A. debug pm pki enable
B. debug cert events enable
C. debug capwap events enable
D. debug capwap packet enable
E. debug capwap errors enable

Answer: E