Real JN0-661 Juniper Networks Exam Question Samples For Free

TestActual is providing JN0-661 exam preparation material for Juniper Service Provider Routing and Switching JN0-661 exam for last 10 years and has gathered more then 50,000+ satisfied customers around the world. Our success rate for Juniper Service Provider Routing and Switching JN0-661 exam is remarkable. You may try the free demo of our Juniper Service Provider Routing and Switching JN0-661 exam dumps material, before purchase. We provide you latest JN0-661 exam questions. The candidates will also be entitled 90 days free updates.

♥ VALID JN0-661 Exam Questions 2018 ♥

JN0-661 exam questions, JN0-661 PDF dumps; JN0-661 exam dumps:: https://www.dumpsschool.com/JN0-661-exam-dumps.html (133 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)

Latest Juniper JN0-661 Dumps Exam Questions and Answers:

Version: 8.0
Question: 21

Which two statements describe the benefits of using point-to-multipoint LSPs in an environment with MVPNs? (Choose two.)

A. Performance levels within the LSPs can be guaranteed, regardless of the signaling protocol used.
B. A service provider network does not need to run PIM to support multicast routing.
C. Data replication can be done by downstream LSRs and not just by the ingress PE router.
D. Multicast traffic can be protected, regardless of the signaling protocol used.

Answer: B C

Question: 22

What are two requirements of Layer 2 VPN BGP route reflectors? (Choose two.)

A. Routes are kept in the bgp.l2vpn.0 table.
B. Route reflectors must support the l2vpn family.
C. Route reflectors must support the inet-vpn family.
D. Routes are kept in the inet.2 table.

Answer: A B

Question: 23

Referring to the exhibit, you have configured an L3VPN that connects Site-1 and Site-2 together, but the BGP routes are being hidden on the PE routers. The topology in this scenario is shown below.
Site-1 > PE-1 > P-1 > P-2 > PE-2 > Site-2
Which two acttions would allow communication Site-1 and Site-2? (Choose two.)

A. Disable CSPF on under MPLS on P-1 and P-2.
B. Configure DGP on P-1 and P-2.
C. Enable RSVP for all interfaces on P-1 and P-2.
D. Enable LDP for all interfaces on all routers.

Answer: C, D

Question: 24

A layer 2 circuit (RFC 4447) is established between two PE routers to provide connectivity between two customer sites. Which two statements related to this deployment are true?

A. Kompella encapsulation is used in the data plane communications.
B. LDP must be used for the control plane communications
C. BGP must be used for the control plane communications.
D. Martini encapsulation is used in the data plane communications.

Answer: B, D

Question: 25

Referring to the exhibit, which router will be the RP?

A. R4 for all groups
B. R1 for group 224.1.1.11 and R4 for all other groups
C. R1 for all groups
D. R4 for group 224.1.1.12 and R1 for all other groups

Answer: A

Question: 26

You must ensure that r1’s IPv4 loopback address exists in r3’s inet 0 routing table
Referring to the exhibit, which statement is true?

A. An IPv4 unicast realm can be enabled on each router.
B. A policy can be configured on M to redistribute 172.16.100.1/32 into OSPFv2, which would cause r3 to eventually learn the route and place it into inet0.
C. A RIB group can be configured on r3 to copy that route into inet 0 because 172.16.100.1/32 exists in r3’s inet6.0 table
D. A policy can be configured on r1 to redistribute 172 16 100 1/32 into OSPFv3, which would cause r3 to eventually learn the route and place it into inet 0.

Answer: C

New Updated JN0-661 Exam Questions JN0-661 PDF dumps JN0-661 practice exam dumps: https://www.dumpsschool.com/JN0-661-exam-dumps.html